TOVE Software 12/98

This software provides call addmission control
supporting UNI 3.1 signalling.


The starting of the tove software is as follows:


A. Start system services

	A.1.1 start a CORBA naming service
	A.1.2 start a CORBA event service

B. Start tove services 

	B.1	start a tove log daemon
	B.2.1	start a gsmpd daemon
	B.2.2	start a routing daemon
	B.2.3.1	start a scp
	B.2.3.2	start an user interface for the scp if needed

C. Start tove software

	C.1	start a tove software
	C.2	start a configuration user interface
	C.3.1	start an intelligent network gateway
	C.3.2	start a snmp daemon
	C.3.3	start ilmi daemons for each uni interface


The function of the started tove software is as follows:


A. In the startup of every module

	A.1	register itself from a naming service if needed
	A.2	obtain necessary object references from a naming service
	A.3	register itself to other objects as needed

B. In the startup of tove software

Configuration information
	B.1	tove software receives configuration information
		from the user interface

Startup of tove software and nni interfaces
	B.2	tove software receives a startup command from the
		user interface
	B.3	tove software starts the snmp daemon
	B.4	tove software registers the addresses configured
		to nni interfaces to the routing daemon

Startup of uni interfaces
	B.5.1	tove software starts the ilmi daemons 
	B.5.2	when ready the ilmi daemons provide addresses
		registered to uni interfaces to tove software
	B.5.3	tove software registers the provided addresses to
		the routing daemon


C.1, C.2 means that C.1 is started first and the C.2 is started after C.1.
For example, C.3.1 is started after C.2, but before C.3.2.

If you have any questions or comments about this software,
please send email to vmp@tcm.hut.fi

	###